 |
FP9000 Series LIGHTSPEED ™ paddlewheel flow sensors are ideal for applications with low viscosity solutions (like water) which are low in suspended solids. A patented fiber-optic sensing mechanism makes these sensors especially well suited for applications in hazardous environments, where the paddlewheel electronics can be mounted in a non-hazardous location and the near-infrared light signal can be sent down an optic cable to the paddlewheel inside the hazardous location. This non-magnetic design tolerates some rust, often found in iron pipes. FP9000 Series flow sensors must be used with the companion FP9000 Series pipe installation fittings. The high amplitude pulse output from the FP9P opto-electronic interface is ideally suited for hook up to the model INF7 ratemeter/totalizer. For 4-20 mA output, connect to OMEGA’s FLSC90 Series signal conditioner. (Please specify fitting and calibration range for the 4-20 mA output.) The FLSC90 includes the required optical interface for the FP9000 sensor.
Please download PDF below for complete product specifications
|
 |
|
 |
† All dollar amounts on this site are shown in US currency.
Note: Comes with complete product manual
Ordering Example: (1) FP9001 Paddlewheel sensor for pipes 1/2" to 3", (1) FP9010 1" PVC Schedule 80 Fitting, (1) FP9P-T Optical to TTl Pulse Interface, (1) DPF701 1/8 DIN Panel Meter for Rate or Total Indication, (1) DPF700-A Analog Output Card for DPF701 = $830
|
|
 |
|
 |
|  |
 |
 |
 |
 |
 |
 |
 |
 |
 |
Related Links -
Related Products
|
 |
 |
 |
 |
 |
 |
|
Related Products
|
 |
FLSC90-A:
|
Fiber-optic Input Flow Signal Conditioners for Use With Lightspeed Paddlewheel Flow Sensor
|
 |
 |
|
|
 |
Sensor Wire:
|
|
Sensor and Transducer Wire and Multi-Conductor Cable
|
 |
 |
|
|
|
|
 |
 |
|
|
Keywords:LightspeedTM Fiber Optic Paddlewheel Flow Sensors Inherently Safe Design
|
Back to top |
|