The FPUC200 has been discontinued. Please contact our Flow
and Environmental department for possible substitutes.
All major pump parts in the FPUC200 Series are precision molded of tough, corrosion-resistant
glass-reinforced polyester or Noryl glass-reinforced thermoplastic. These high-strength plastics provide
resistance to water and salt water as well as to many acids, bases and solvents. O-rings and seals are of
EPDM, FKM, or Buna-N. They utilize 18-8 SS wetted internal hardware. For extra corrosive
service, the motor shaft adaptor can be made of titanium, the impeller screw can be encapsulated in
polypropylene, and the mechanical seals can be made metalless with FKM and siliconized graphite seal
faces (add suffix “-TPV” to the model number and add $700 to price), or the mechanical seals can be made
metalless with EPDM and siliconized graphite seal faces (add suffix “-TPM”
and add $638 to price).
WARNING:
When pumping flammable or combustible liquids, all containers must be effectively bonded and
grounded to prevent sparks of static electricity which could cause an explosion
*GPM @ 1725 & 3450 RPM, 60 cycle motors: LPM @ 1450 & 2850
RPM, 50 cycle motors. For Noryl body instead of polyester, add suffix
“-NL” to model numbers, and add $45 to price. For optional Buna-N
or FKM elastomers, add suffix “-B” or “-V” to model number and add
$138 for FKM, no charge for Buna-N. For 50 Hz motor, please
specify ”-Voltage/Phase/50 Hz” (consult OMEGA'S Flow Engineering
Department for price). To order an EDPM fitted hard siliconized graphite faced shaft seal for abrasive
applications, add suffix “-SC” to model number and add $215 to price.
MOST POPULAR MODELS HIGHLIGHTED!
† All dollar amounts on this site are shown in US currency.
