Clean Water Immersion Heater 1¼" NPT Fitting |
| MT-1 Series |
|
 |
|
|
|
 |
The MT-1 series immersion heater is ideally suited for clean water requirements.
Models are available with a general purpose terminal enclosure1 or a rugged
moisture resistant explosion resistant terminal enclosure.
Please Note: This immersion heater should be used with an approved temperature
control device to assure safe operation. See Section P for our complete selection
of process controllers.
CAUTION AND WARNING!
Fire and electrical shock may result if products are used improperly
or installed or used by non-qualified personnel. See inside back
cover for additional warning.
MT-1 Series
E1 General Purpose Encl.1
Model No. |
E2 Explos. Res./ Moist Res Encl.2
Model No. |
kW |
Phase |
W/in2 |
No.
Elem. |
Dim. B
in (cm) |
| MT-160A/* | MT-160E2/* | 0.6 | 1 | 53 | 1 | 6 1/8 (16) |
| MT-175A/* | MT-175E2/* | 0.75 | 1 | 65 | 1 | 6 1/8 (16) |
| MT-110A/* | MT-110E2/* | 1 | 1 | 86 | 1 | 6 1/8 (16) |
| MT-110-3A/* | MT-110-3E2/* | 1 | 1 | 43 | 2 | 6 1/8 (16) |
| MT-112A/* | MT-112E2/* | 1.2 | 1 | 53 | 2 | 6 1/8 (16) |
| MT-115A/* | MT-115E2/* | 1.5 | 1 | 65 | 2 | 6 1/8 (16) |
| MT-120A/* | MT-120E2/* | 2 | 1 | 86 | 2 | 6 1/8 (16) |
/* Designate voltage, insert 120 for 120 VAC or 240 for 240 VAC. Higher wattages available - contact OMEGALUX.
1. Heaters with General Purpose and Moisture Resistant Enclosures are UL Listed and CSA Certified.
2. Heaters with Explosion Resistant Enclosures are CSA NRTL/C certified and are not intended for use in hazardous areas.
|
| |
|
|
|
|
|
† All dollar amounts on this site are shown in US currency.
|
|
|
|
|
|
|
|
 |
|
 |
|
|
Part Number Builder |
|
|
|
|
|
 |
|
|
|
|
|
Option Descriptions
|
|
(1)
|
Code in Part Number(from table above)
|
| |
Select
160 for code 160
175 for code 175
110 for code 110
110-3 for code 110-3
112 for code 112
115 for code 115
120 for code 120
|
(2)
|
Enclosure
|
| |
Select
A for general purpose enclosure
E2 for E2 moisture tight explosion resistant enclosure
|
(3)
|
Voltage
|
| |
Select
120V for 120 Vac
240V for 240 Vac
|
|
NOTE: All combinations may not be valid, check spec sheet for valid part numbers.
|
| |
|
|
|
|
|
|
|
|
Keywords:Clean Water Immersion Heater 1¼" NPT Fitting
|
Back to top
|
