This general purpose RTD probe transitions directly to 36" lead wires without the use of a metal transition fitting. This design makes for a more compact probe when space limitations are a factor. Note that the point where the lead wire exits the probe sheath will not be as durable as on the PR-11 probe, which uses the metal transition and spring as strain relief.
For special options consult Sales or Temperature Engineering for availability and pricing.
† All amounts shown in USD Note:
For 4-wire configurations change the "2" in the model number to a "3" and add $15 to the price (4-Wire Configuration Not Available in 1/8" or 3mm Probe Diameters).
To order with shrink tube strain relief, specify "-ST" at end of model number. To order probes in intermediate lengths, change model number, using next longer probe price. Over 24", add $1 per inch of probe length. Stainless steel overbraid or BX cable also available. For leads longer than 40", add lead length to end of model number and $2.25 per foot to the price. Ordering Example: (1) PR-10-2-100-1/4-12-E RTD probe, lead type 2 (3-wire configuration), 100 ohms, 1/4, $70.00
Part Number Builder
Build Your Part Number Below
Probe Diameter select from: 1/8 for 1/8 inch 3/16 for 3/16 inch 1/4 for 1/4 inch
Sheath Length select from: 6 for 6 inch 12 for 12 inch 18 for 18 inch 24 for 24 inch CUSTOM for custom length in inches(whole numbers only 2 to 72 )
Note: All combinations may not be valid, check spec sheet for valid part numbers.