Models SRTD-1 and SRTD-2 are polyimide insulated surface mount RTD temperature sensors designed to provide a practical method for measuring surface temperatures. These sensors are small and flexible, and their low mass has minimal thermal effect on the material being measured. They are ideally suited for applications where the sensor can be mounted to the surface being measured using adhesives (OMEGABOND® 101 and 200 epoxies can be used) or other mechanical mounting methods.
† All amounts shown in USD Note: Additional lead wire is available, add suffix “-X” (where X is length in inches) to model number and add $5.00 for each additional foot or fraction thereof to price. Comes with complete instructions. (OPTIONS SHOWN IN THIS "NOTE" ABOVE ARE PRICED IN US$) Ordering Example: (1) SRTD-1 Cement-On RTD with 36'' of lead length, stripped end termination, ±0.50% accuracy, $184.00
Part Number Builder
Build Your Part Number Below
Sensing Element and Accuracy select from: 1 for Sensing element 100.00 ±0.50 OHM at 0°C. Accuracy ±0.50% of temperature reading 2 for Sensing element 100.00 ±0.22 OHM at 0°C. Accuracy ±0.25% of temperature reading
Length select from: Nothing(leave field blank) for 36 in -48 INCH for 48 in -60 INCH for 60 in -72 INCH for 72 in -78 INCH for 78 in -84 INCH for 84 in -96 INCH for 96 in -120 INCH for 120 in -180 INCH for 180 in -300 INCH for 300 in -360 INCH for 360 in
Connector select from: Nothing(leave field blank) for None -MTP for MTP connector -TA3F for TA3F connector
Note: All combinations may not be valid, check spec sheet for valid part numbers.