DIN Rails, 35x7.5 mm & 35x15 mm, Standard and Pre-Cut LengthsDIN Rails, Standard and Pre-Cut Lengths
Please add to cart to keep it or exit the configuration
- 35x7.5 mm & 35x15 mm in 1 Meter & 2 Meter Lengths
- Steel with Electrolytic Zinc Plating
- Pre-Cut Lengths for Standard Sub-Panel Widths
- Stand-Off Brackets: 45° Angle and Straight
- Comply with DIN 50045, 50022 and 50035 Standards
Edit OptionsView all models
Not all combinations are valid. Options compatible with previous selections will be in bold.
*Highlighted options are not compatible. Please select a different combination.
The DRTB-Rails Series DIN Rails enhances design capabilities, saves space and reduces labor. DIN rails have been accepted throughout the world, allowing the designer to mount a wide variety on control components, devices and terminal blocks, etc. on the same rail. DRTB-Rails are perforated steel with electrolytic zinc plating and available in 35x7.5mm and 35x15 mm sizes. These DIN rails comply with DIN 50045, 50022 and 50035 standards.
Pre-Cut DIN Rails
Pre-cut DIN rails are offered in widths to match enclosure sizes. An enclosure, 12H x 10” W, would use DRTB-RAIL-10. This DIN rail measures 8.75' wide, just short of the 8.88' wide sub-panel.
Support brackets elevate DIN rails away from the sub-panel to facilitate component wiring access. Angled brackets tilt the DIN rails by 45° to improve visibility. Straight brackets are available in three heights for optimum positioning of the rails.
Brackets include screws
& lock washers